We show the work on the right headlamp; in the left headlamp, we change the lamps in the same way.
2290-18-8-01
To replace the indicator lamp, turn the lamp holder counterclockwise and remove the lamp holder from the body of the headlamp.
2290-18-8-02
Having pressed a lamp, we turn it counterclockwise against the stop and we take out a lamp from a cartridge.
Install the new PY21W lamp in the reverse order.
In this case, two protrusions located asymmetrically relative to the axis of the lamp should enter the corresponding grooves of the cartridge.
Headlight bulb replacement
2290-18-8-04
To replace the headlight lamp, disconnect the wiring block from the lamp.
2290-18-8-05
Remove the rubber protective cover.
2290-18-8-11
Having squeezed the ends of the spring clip of the lamp, we disengage them from the hooks of the reflector (for clarity, shown on the removed headlamp).
2290-18-8-06
Pull the latch up.
2290-18-8-07
We take out the lamp from the body of the headlamp.
Attention! The headlight is halogen. Do not touch her glass bulb with your fingers, as traces of them will cause the lamp to darken when heated. You can remove contamination from the flask with a clean rag soaked in alcohol
Install the new H4 lamp in the reverse order.
2290-18-8-08
We install the protective cover so that the arrow on the cover coincides with the mark on the body of the headlamp.
Replacing the side light bulb
To replace the side light bulb, remove the protective cover (see above).
2290-18-8-09
Pulling, take out the cartridge with the lamp from the body of the headlamp (for clarity, shown on the removed headlamp).
2290-18-8-10
Pulling the lamp, take it out of the holder.
