Kia cee'd
LED strip - 350-460 rubles. Fuse holder - 30-40 rubles. The trailer - 190-300 rubles. LED strip - 350-460 rubles. Fuse holder - 30-40 rubles. The trailer - 190-300 rubles.
An interesting version of the illumination was proposed by Sergey Nikolotov, known on the profile forum under the nickname Forstr. As a light source, he chose a 30-cm LED strip Sho-Me SMD-1210-18-30. You will also need the accompanying small things: an electric cable, corrugation, clamps, a fuse holder for cars FH-501-1, a fuse for 5A, a hood end cap, a heat shrink tube. Total costs are small and amount to several hundred rubles.
one
We mount the LED strip on a self-adhesive base and additionally with clamps. The most suitable place is on the “step” of the hood upholstery. We mount the LED strip on a self-adhesive base and additionally with clamps. The most suitable place is on the “step” of the hood upholstery.
2
Extending the cable from the tape, we extend it under the hood upholstery (along the very edge, near the caps) and draw it to the left (in the direction of travel) loop. Extending the cable from the tape, we extend it under the hood upholstery (along the very edge, near the caps) and draw it to the left (in the direction of travel) loop.
3
Next, we pass the cable through the hood loop (in a similar way, the “washer” hose passes through the loop on the other side). We extend the cable under the rubber of the hood seal. Next, we pass the cable through the hood loop (in a similar way, the “washer” hose passes through the loop on the other side). We extend the cable under the rubber of the hood seal.
four
We cut the trailer into the plastic of the headlights (it is better if it is adjustable). Do not pay attention to the second trailer in the photo - it is “tied” to the alarm system installed on Sergey’s car. We cut the trailer into the plastic of the headlights (it is better if it is adjustable). Do not pay attention to the second trailer in the photo - it is “tied” to the alarm system installed on Sergey’s car.
five
The “minus" of the cable is connected to the trailer through the terminal. Next, screw the “plus” of the cable to the end of the fuse holder (the holder wire must be cut in half). The “minus" of the cable is connected to the trailer through the terminal. Next, screw the “plus” of the cable to the end of the fuse holder (the holder wire must be cut in half).
6
We attach a terminal to the other end of the holder, fasten it to the "plus" of the battery. We attach a terminal to the other end of the holder, fasten it to the "plus" of the battery.
7
We put the whole wire in the corrugation. We put the whole wire in the corrugation.
eight
And we fix the cable with clamps, clinging to improvised fasteners, holes in the loop, hood, etc. And we fix the cable with clamps, clinging to improvised fasteners, holes in the loop, hood, etc.
